Re: Woody, 2.4.17, pcmcia, xircom-cb, the universe and me
Maybe a stupid question, but isn't cardmgr supposed to recognize the
card by itself? How do I force it to xircom_tulip_cb?
Bernd
On Thu, 2002-01-24 at 19:40, Art the Lemming wrote:
> I've had intermittent problems with the xircom_cb kernel module. You
> might try using the xircom_tulip_cb driver; I've found better success
> with it.
>
> A.
>
> On Thu, 2002-01-24 at 13:38, Bernd Kunze wrote:
> > Hi,
> >
> > just migrated from RH 7.1 to woody. I did install the 2.4.17 kernel plus
> > pcmcia-cs. However, when pcmcia is started it does not recognize and
> > load the driver for the xircom card. Even if I load the driver manually
> > and start /etc/pcmcia/network start xircom_cb the ifuser seems to hang
> > for 2 minutes and lock the card. After ifuser terminates, I hear a beep.
> >
> > If I use modconf to load the modules during kernel load, I am ok (with
> > the side effect I can not use netenv though).
> >
> > Am I totally off record or is this a known problem?
> >
> > Thx.,
> > Bernd
> > --
> >
> > Bernd Kunze bkunze@unispherenetworks.com
> > Technical Program Manager
> > http://www.unispherenetworks.com
> > Unisphere Networks
> >
> > GSM : +49 172 297 4707
> > Home Office : +49 202 6084789
> >
> >
> > --
> > To UNSUBSCRIBE, email to debian-testing-request@lists.debian.org
> > with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
> >
>
--
Bernd Kunze bkunze@unispherenetworks.com
Technical Program Manager
http://www.unispherenetworks.com
Unisphere Networks
GSM : +49 172 297 4707
Home Office : +49 202 6084789
Reply to: