Matrox and Opengl howto????
hi...
I just install the mplayer and zsnes
I plus the opengl with both software...
However, when I try to use them with the OpenGL.
It got too slow.
almos 1fp!!!
I use the G450 and the driver from the www.matrox.com
My XF86Config-4 had
Section "Module"
Load "ddc"
Load "GLcore"
Load "dbe"
Load "extmod"
Load "glx"
Load "dri"
Load "pex5"
Load "record"
Load "xie"
Load "bitmap"
Load "xtt"
Load "speedo"
Load "type1"
Load "vbe"
#Load "int10"
EndSection
Section "Device"
Identifier "MATROX CARD 1"
Driver "mga"
VideoRam 32768
Option "AGPMode" "2"
Option "hw cursor" "on"
BusID "PCI:1:0:0"
EndSection
Section "DRI"
Mode 0666
EndSection
Anything wrong with my setup steps??
I also used the xlibmesa. The apt remove the mesag3..Is it needed???
Thanks for answering
Reply to: