On 07.07.2012 17:53, Gary Dale wrote:
On 07/07/12 09:04 AM, Michael Tokarev wrote:
On 07.07.2012 16:25, Gary Dale wrote:
[]
I copied you in on it because this seems to a new behaviour in the krfb and/or kvm software.
It is not. For qemu/kvm case, you have to tell it explicitly where
(on which port) to listen. This has always been the case. So you
either told qemu-kvm directly to use port 5901, or configured it
using libvirt. For krbf it is the most logical port to listen on,
but I can't comment on it since I know nothing about it.
OK, I think I get it now. A couple of days ago, you had me install librbd1 from sid. Perhaps I didn't have that software running earlier. It would have grabbed 5900, bumping KVM up to 5901 - which was the port I normally used for remote VNC sessions. This would now cause the error I was getting.
librbd has exactly nothing to do with this either.
it is just a library, linked from qemu-kvm, which
does not use VNC ports. More, previous versions
of qemu and qemu-kvm used the same library but an
older version of it.
krfb which uses your port 5900 is completely independent
on qemu, kvm and librbd.
/mjt