| Looking for help in trying to install Debian on a 280R. I am getting the following output when trying to do a boot from cd after the initial boot screen: (2 X UltraSPARC-III+) , No Keyboard Copyright 1998-2003 Sun Microsystems, Inc. All rights reserved. OpenBoot 4.10.1, 4096 MB memory installed, Serial #53710923. Ethernet address 0:3:ba:33:90:4b, Host ID: 8333904b. Rebooting with command: boot cdrom Boot device: /pci@8,700000/scsi@6/disk@6,0:f File and args: SILO Version 1.4.13 \ Welcome to Debian GNU/Linux etch! This is a Debian installation CDROM, built on 20070820-20:30. Keep it once you have installed your system, as you can boot from it to repair the system on your hard disk if that ever becomes necessary. WARNING: You should completely back up all of your hard disks before proceeding. The installation procedure can completely and irreversibly erase them! If you haven't made backups yet, remove the rescue CD from the drive and press L1-A to get back to the OpenBoot prompt. Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent permitted by applicable law. [ ENTER - Boot install ] [ Type "expert" - Boot into expert mode ] [ Type "rescue" - Boot into rescue mode ] boot: Allocated 8 Megs of memory at 0x40000000 for kernel Loaded kernel version 2.6.18 Loading initial ramdisk (3878328 bytes at 0xFF802000 phys, 0x40C00000 virt)... Illegal Instruction {0} ok Any assistance would be appreciated. TIA Joseph Jenkins www.pixadmin.com |