Re: Creator3d modes
Hi,
the Creator 3D supports the following resolutions:
resolution refreshrate standard buffering
1920 x 1200 70 Hz Sun Single Buffered
1600 x 1200 75 Hz VESA Single Buffered
1600 x 1000 66,76 Hz Sun Single Buffered
1440 x 900 76 Hz Sun Double Buffered
1280 x 1024 75, 85 Hz Vesa Double Buffered
1280 x 1024 60, 67, 76, 85 Hz Sun Double Buffered
1280 x 800 66, 76 Hz Sun Double Buffered
1152 x 900 66, 76 Hz Sun Double Buffered
1024 x 800 84 Hz Sun Double Buffered
1024 x 768 60, 75 Hz VESA Double Buffered
960 x 680 108, 112 Hz Sun-Stereo Double Buffered
800 x 600 75 Hz VESA Double Buffered
768 x 575 50i Hz PAL Double Buffered
640 x 480 60 Hz Sun, VESA Double Buffered
640 x 480 60i Hz NTSC Double Buffered
Greets,
Oliver
koda80 (sent by Nabble.com) wrote:
My creator3d will run 1280x1024 fine, the only higher resolutions i've found
that work are 1600x1000x60 and 1440x900x70; great if I had a 16:9, but my
gdm20e20 is capable of much more, why can't I run a 4:3 mode higher than the
5:4 1280 mode? BTW sun ultra10 440mhz running dual head in x at
1280x1024(creator3d ffb+2) and 1024x768(on a 17" with the built-in ati card)
the 1600x1200 mode or 1440x1080 set in OBP revert back to 1280x1024 on
reset, or cause the out of range blinky led on the monitor (depending on the
refresh I give it) those modes should run anywhere between 60 and 66hz,
checked them with the modeline creator(pretty good check of monitor
capabilities), is it my card limit, or monitor limit? I can't seem to get
real specs (supported resolutions) on either the card or monitor, but I have
the proper sync rates for the monitor and modelines for x up to
1600x1200x60.
--
View this message in context: http://www.nabble.com/Creator3d-modes-t1156371.html#a3034021
Sent from the debian-sparc forum at Nabble.com.
--
("`-''-/").___..--''"`-._
`6_ 6 ) `-. ( ).`-.__.`)
(_Y_.)' ._ ) `._ `. ``-..-'
_..`--'_..-_/ /--'_.' ,'
(il),-'' (li),' ((!.-' Oliver Harwart <oliver@harwart.de>
Reply to: