Re: Creator3d and better resolution

[Oliver Harwart <oliver@harwart.de>]

Hello koda80,

the screen resolution can be changed in the OBP.

You can check the current setting with

printenv output-device

This would set a 1280x1024 resolution with 60Hz refresh rate:

setenv output-device screen:r1280x1024x60

When using PCI graphics this might be somewhat different. You should 
first check the current settings in OBP.

hth,

Oliver

koda80 (sent by Nabble.com) schrieb:

> I got Sarge running on my U10 with a creator3d, but I cannot get it above
> 1280x1024 on my GDM-20e20, which is capable of at least 1600x1200, the
> creator3d will go to 1920x14something, I just want 1600x1200 is there a tool
> like sax I can use, I've tried setting it in xf86config, but it automagicly
> sets the display to 1280x1024-24bpp, I am used to suse10 on x86 since my old
> SS20 will only run debian woody.  Please help
>
> --
> View this message in context: http://www.nabble.com/Creator3d-and-better-resolution-t1122294.html#a2935758
> Sent from the debian-sparc forum at Nabble.com.
>
>
>  


--
   ("`-''-/").___..--''"`-._
    `6_ 6  )   `-.  (     ).`-.__.`)
    (_Y_.)'  ._   )  `._ `. ``-..-'
  _..`--'_..-_/  /--'_.' ,'
 (il),-''  (li),'  ((!.-'    Oliver Harwart <oliver@harwart.de>