SunFire v240 & Debian - Getting Closer

["Jared Valentine" <hidden@xmission.com>]

Installing Debian on a SunFire v240.  System freezes towards the end of the
kernel booting with this being the last message:

Failed to mount /selinux/: No such file or directory

Here's the full installation-report.  Any help would be appreciated.

Thanks,

Jared Valentine
hidden@xmission.com



Package: installation-reports

Boot method: TFTP/RARPD
Image version: Downloaded 02/10/2006,
http://people.debian.org/~stappers/d-i/images/daily/sparc64/netboot/2.6/
Date: 02/10/2006
Machine: SunFire v240 (headless, all config through serial)
Processor: dual 1002mhz
Memory: 2048mb
Partitions: /dev/sda1 is /boot, 90mb, ext3, boot flag
		/dev/sda2 is /, remainder of disk, ext3
		/dev/sda3 is Sun "whole disk"
		/dev/sda4 is swap 

Output of lspci and lspci -n:  Unknown

Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot worked:    [O]
Configure network HW:   [O]
Config network:         [O]
Detect CD:              [None Installed]
Load installer modules: [O]
Detect hard drives:     [O]
Partition hard drives:  [O]
Create file systems:    [O]
Mount partitions:       [O]
Install base system:    [O]
Install boot loader:    [O]
Reboot:                 [O]

Comments/Problems:  Previous installation attempts (over the last 6 months)
have always frozen at "Remapping the kernel. Done."  I pulled down a daily
image today from the above-mentioned location.  The Debian installer worked
this time, system rebooted, and this kernel actually boots.  It looks like
it boots almost the entire way through the kernel.  The last few messages
listed are:

Kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Switching root .
Failed to mount /selinux/: No such file or directory (from here it hangs)