[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Full Duplex in Happy Meal Network interface



On 9/14/06, Gustavo Mendes de Carvalho <gmcarvalho@gmail.com> wrote:
Hello there,

I´m using a Debian Sarge version for Sparc, running in a E420, and when
I run ethtool command, I get

server:~# ethtool eth0
Settings for eth0:
       Supported ports: [ TP MII ]
       Supported link modes:   10baseT/Half 10baseT/Full
                               100baseT/Half 100baseT/Full
       Supports auto-negotiation: Yes
       Advertised link modes:  Not reported
       Advertised auto-negotiation: No
       Speed: 100Mb/s
       Duplex: Half
       Port: Twisted Pair
       PHYAD: 0
       Transceiver: internal
       Auto-negotiation: on


What can I do to get a Full duplex setting in a Happy Meal interface card?

Force both sides of the link to 100/full.  I recall HMEs having
difficulty autonegotiating with certain network equipment.


This server has a quad ethernet card, and I have no cable connected
there, and because of that I´m receiving this messages

eth1: Link down, cable problem?
eth2: Link down, cable problem?
eth3: Link down, cable problem?
eth4: Link down, cable problem?
eth1: Auto-Negotiation unsuccessful, trying force link mode
eth2: Auto-Negotiation unsuccessful, trying force link mode
eth3: Auto-Negotiation unsuccessful, trying force link mode
eth4: Auto-Negotiation unsuccessful, trying force link mode


What do I have to do to stop to generate this messages ?

Set the interfaces to be administratively "down" rather than "up."

Thanks,
E


Thanks for now

--

Gustavo Mendes de Carvalho
gmcarvalho@gmail.com





--
E



Reply to: