Re: sungem
On Thu, Mar 27, 2003 at 11:51:27AM -0800, cash@polarcom.com wrote:
> Hello,
>
> Debian woody on a dual ultrasparc. I have a 1000b-sx Gb ethernet card.
> I have re-compiled the kernel and have the sungem as a loadable module.
> It loads fine and I can assign an IP address. This is hooked up to a cisco
> catalyst 4000. I can move traffic around for about 45 seconds then it
> dies for 2 minutes, it comes back traffic goes for another 45 seconds and
> then dies again. I have tried the different link modes and all of them
> have the same issue. I have tried different cables same problem.
> different Gbics in the cisco, same problem.
>
> Has anybody else had these problems?
> Anybody have a solution or any ideas on what I could try to get this working?
Tried different IP's? Sounds to me like you are getting some ARP
corruption.
--
Debian - http://www.debian.org/
Linux 1394 - http://www.linux1394.org/
Subversion - http://subversion.tigris.org/
Deqo - http://www.deqo.com/
Reply to:
- References:
- sungem
- From: <cash@polarcom.com>