scsi tape changer problems
hi,
i'm trying to test out a tape changer with an ultra 10, but it keeps
giving me errors. i was able to control the changer for a little,
but not anymore. it won't get past that scsi driver loading--it
continually gives error messages and doesn't complete the boot, now.
this is a 2.4.18 kernel. 2.2.20 gave similar results.
May 1 13:24:53 copper kernel: qlogicisp : new isp1020 revision ID (5)
May 1 13:24:53 copper kernel: scsi0 : QLogic ISP1020 SCSI on PCI bus 03 device 20 irq 6277376 MEM base 0x1ff02808000
May 1 13:24:53 copper kernel: Vendor: ADIC Model: FastStor DLT Rev: 132D
May 1 13:24:53 copper kernel: Type: Medium Changer ANSI SCSI revision: 02
May 1 13:24:53 copper kernel: scsi0 channel 0 : resetting for second half of retries.
May 1 13:24:53 copper kernel: SCSI bus is being reset for host 0 channel 0.
May 1 13:24:53 copper kernel: scsi : aborting command due to timeout : pid 4, scsi0, channel 0, id 3, lun 0 Inquiry 00 00 00 ff 00
May 1 13:24:53 copper last message repeated 25 times
May 1 13:24:53 copper kernel: sunmouse: Successfully adjusted to 1200 baud.
May 1 13:24:53 copper kernel: scsi : aborting command due to timeout : pid 4, scsi0, channel 0, id 3, lun 0 Inquiry 00 00 00 ff 00
May 1 13:24:53 copper kernel: scsi : aborting command due to timeout : pid 4, scsi0, channel 0, id 3, lun 0 Inquiry 00 00 00 ff 00
May 1 13:24:53 copper kernel: qlogicisp : unknown completion status 0x001e
May 1 13:24:53 copper kernel: Attached scsi generic sg0 at scsi0, channel 0, id 2, lun 0, type 8
--
To UNSUBSCRIBE, email to debian-sparc-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: