Re: Help error messages bootiing rescue disks

[Eric Delaunay <delaunay@lix.polytechnique.fr>]

Floyd Rodgers wrote:
> Trying to initial load sparc2 via floppies results in these messages.
> fatal error: cannot read file system
> error: bad or malformed address
> 
> 2g disk set to address 1.  Any ideas?
> Is there any place in Dallas to buy a CD version?

I never managed to get reliable floppy install on my sparc2 :((
I'm inclined to blame my floppy drive because it works some times just after a
cold boot but leaving the box switched on for one hour or so give the floppy
non functional :((
Could you try a net install instead ?
Regards.

-- 
 Eric Delaunay                 | "La guerre justifie l'existence des militaires.
 delaunay@lix.polytechnique.fr | En les supprimant." Henri Jeanson (1900-1970)