Re: setserial configuration
On Sun, Apr 18, 1999 at 06:31:36AM -0400, Harold Hartley wrote:
> Hi,
> I have a sparc 1+ and when I boot up the system it shows me this message
> about the serial configuration in the following:
>
> Configuring serial ports...Cannot autoconfigure port: Invalid argument
> setserial was unable to configure the serial ports
> Aborting serial configuration. Check the serial modules...
> run-parts: /etc/rc.boot/0setserial exited with return code 1
> INIT: Entering runlevel: 2
>
> and then starts the rest of the stuff...
> I also figure my serial ports as ttyS0 for serial port 1
> and ttyS1 for serial port 2 on my sparc 1+
>
> hope someone can help me on this so I can set the serial ports...
I get the same messages, not sure what it is, but it doesn't affect the
use of the serial ports.
--
----- -- - -------- --------- ---- ------- ----- - - --- --------
Ben Collins <b.m.collins@larc.nasa.gov> Debian GNU/Linux
OpenLDAP Core - bcollins@openldap.org bcollins@debian.org
UnixGroup Admin - Jordan Systems The Choice of the GNU Generation
------ -- ----- - - ------- ------- -- ---- - -------- - --- ---- - --
Reply to: