Re: more kernel problems

[Daniel Urbach <greywuuf@alaska.net>]

Stephen Zander wrote:

 That suggests that a SCSI device that was found probing the bus is no
> longer responding.  Are you sure that the previous kernel worked?
> What is at SCSI id 0?


I am I sure the old kernel worked ? 
I may be new to the sparc platform  but I can tell when it Boots up and
runs  <grin>  Yes I have on kernel in my silo.conf that runs and
everything else ( either compiled by me  or images from Debian.org or
even incoming) gives me the error 

What is on Device 0 ?    Nothing there never has been anything on scsi
0  I have device 1 ( root hard drive )  device 3 ( old small hard drive
mounted on /xtra  just cause I couldn't se not using it )  and device 6 
a PLextor 2x cdrom the working kernel came from boot disks from debian
.org and I think they were actually the potato disks at the time as the
slink disks failed to load the drivers disk. I got a clean compile with
the source of 2.1.125 no patches apllied ( by me at least ) I got the
source from Debian  in the sparc source Dir. and I have also tried a
kernel image of 2.2  both exhibit the  probing device zero error.

Thanks for the suggestion everyone  but I do not have a solution as of
yet ?

 I have not tried moving a device to  target 0 as I dont feel it should
be needed ( I have one kernel that works after all ) 


Dan 

Ps please reply to the greywuuf@alaska.net address as I am sending this
via another account do to isp problem     this acount actually belongs
to someone else and I dont check mail here