vctc link not working on 2.4.19 under VM - followup
Greetings again;
I rebooted and now neither link, eth0 or ctc0, is activated at boot.
I can bring up the ctc by hand, setup the routes, and wonder of
wonders, it works!
However, if I try to do anything to the eth link I get the following.
ifconfig eth0
Starting lcs module $Revision: 1.132 $ $Date: 2002/04/30 19:13:38 $
with chandev support,with multicast support, with ethernet support, with
token ring support.
debug: lcs: new level 0
drvr globals not in list 01c8b000
lcs_probe kmalloc failed
No lcs capable cards found
Terminating lcs module.
eth0: error fetching interface information: Device not found
-arsenic:~-# 00:
00: CP Q OSA
00: OSA 070E ON OSA 070E SUBCHANNEL = 0000
00: OSA 070F ON OSA 070F SUBCHANNEL = 0001
I changed my /etc/network/interfaces file and here it is
iface eth0 inet static
address 10.80.20.33
netmask 255.0.0.0
network 10.0.0.0
broadcast 10.255.255.255
up ifconfig eth0 mtu 1492
gateway 10.80.20.1
# The second network card - this entry was created by hand
iface ctc0 inet static
address 192.168.150.33
netmask 255.255.255.0
network 192.168.150.0
pointopoint 192.168.150.31
up ifconfig ctc0 mtu 1492
up route add -net 192.168.150.0 netmask 255.255.255.0 gw
192.168.150.31
gateway 192.168.150.31
Hope this helps!
Many TIA,
Dennis
--
Dennis G. Wicks Systems Programmer dennisw@cdg.ws
Communications Data Group Tel: (217)355-7117 Fax: (217)351-6994
102 S. Duncan Rd.
Champaign, IL 61822
Reply to: