Re: траблы с флешками
> > hub.c: new USB device 00:1f.2-2, assigned address 3
> > usb.c: USB device 3 (vend/prod 0xea0/0x2168) is not claimed by any
> > active driver
> > .
> > Initializing USB Mass Storage driver...
> > usb.c: registered new driver usb-storage
> > scsi1 : SCSI emulation for USB Mass Storage devices
> > Vendor: JetFlash Model: TS512MJF2B Rev: 2.00
> > Type: Direct-Access ANSI SCSI revision: 02
> > WARNING: USB Mass Storage data integrity not assured
> > USB Mass Storage device found at 3
> > USB Mass Storage support registered.
> > Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
> > sda: Unit Not Ready, sense:
> > Current 00:00: sense key Unit Attention
> > Additional sense indicates Not ready to ready change,medium may have
> > changed SCSI device sda: 1024000 512-byte hdwr sectors (524 MB)
> > sda: Write Protect is off
> > /dev/scsi/host1/bus0/target0/lun0: p1 p2 p3 p4
> > usb_control/bulk_msg: timeout
> > usb_control/bulk_msg: timeout
> > usb_control/bulk_msg: timeout
> > usb_control/bulk_msg: timeout
> > usb_control/bulk_msg: timeout
> > usb_control/bulk_msg: timeout
> > usb_control/bulk_msg: timeout
> > usb_control/bulk_msg: timeout
> > usb-storage: host_reset() requested but not implemented
> > scsi: device set offline - command error recover failed: host 1
> > channel 0 id 0 lun 0 SCSI disk error : host 1 channel 0 id 0 lun 0
> > return code = 6050000 I/O error: dev 08:01, sector 0
> > FAT: unable to read boot sector
>
> Похоже, что дело в заиможействии usb и scsi. Как собрано ядро? В каком
> порядке загружаются модули?
ядро Дебиановское
2.4.24, 2.4.26, 2.6.8 один хфиг
> Можно попробовать вкомпилить намертво и scsi, scsi-disk и usb,
> usb-storage.
Reply to: