Re: траблы с флешками
On Tue, 2 Nov 2004 16:37:05 +0300
Dmitry E. Oboukhov wrote:
> hub.c: new USB device 00:1f.2-2, assigned address 3
> usb.c: USB device 3 (vend/prod 0xea0/0x2168) is not claimed by any
> active driver
> .
> Initializing USB Mass Storage driver...
> usb.c: registered new driver usb-storage
> scsi1 : SCSI emulation for USB Mass Storage devices
> Vendor: JetFlash Model: TS512MJF2B Rev: 2.00
> Type: Direct-Access ANSI SCSI revision: 02
> WARNING: USB Mass Storage data integrity not assured
> USB Mass Storage device found at 3
> USB Mass Storage support registered.
> Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
> sda: Unit Not Ready, sense:
> Current 00:00: sense key Unit Attention
> Additional sense indicates Not ready to ready change,medium may have
> changed SCSI device sda: 1024000 512-byte hdwr sectors (524 MB)
> sda: Write Protect is off
> /dev/scsi/host1/bus0/target0/lun0: p1 p2 p3 p4
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb-storage: host_reset() requested but not implemented
> scsi: device set offline - command error recover failed: host 1
> channel 0 id 0 lun 0 SCSI disk error : host 1 channel 0 id 0 lun 0
> return code = 6050000 I/O error: dev 08:01, sector 0
> FAT: unable to read boot sector
Похоже, что дело в заиможействии usb и scsi. Как собрано ядро? В каком
порядке загружаются модули?
Можно попробовать вкомпилить намертво и scsi, scsi-disk и usb,
usb-storage.
Reply to: