Re: [SLL] Trying to get 3c59x to work with two 3c900bs ...
"W.D. McKinney" wrote:
>
> Xeno Campanoli <xeno@aa.net> wrote:
> >
> >
> > Adding Swap: 173872k swap-space (priority -1)
> > ne.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov)
> > NE*000 ethercard probe at 0x240: 00 50 ba a0 92 bb
> > eth0: NE2000 found at 0x240, using IRQ 5.
> > eth1: 3c509 at 0x320 tag 1, BNC port, address 00 a0 24 12 64 4b, IRQ 7.
> > 3c509.c:1.16 (2.2) 2/3/98 becker@cesdis.gsfc.nasa.gov.
> > 3c59x.c:v0.99H 12Jun00 Donald Becker and others
> > http://www.scyld.com/network/vortex.html
> > eth2: 3Com 3c900 Cyclone 10Mbps TPO at 0xe400, 00:01:02:6b:43:33, IRQ 9
> > 8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
> > MII transceiver found at address 24, status 1809.
> > Enabling bus-master transmits and whole-frame receives.
> > eth3: 3Com 3c900 Cyclone 10Mbps TPO at 0xe800, 00:50:da:b4:4b:5a, IRQ
> > 10
> > 8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
> > MII transceiver found at address 24, status 1809.
> > Enabling bus-master transmits and whole-frame receives.
> > Serial driver version 4.27 with no serial options enabled
> > ttyS00 at 0x03f8 (irq = 4) is a 16550A
> > ttyS01 at 0x02f8 (irq = 3) is a 16550A
> > eth1: Setting Rx mode to 1
> > addresses.
> >
> > Now I noticed both have "Address 24", but other than that, I see no
> > obvious potential problem, and even the latter isn't necessarily wrong.
> > I don't really know. I guess it's back to Rubini. Any help or
> > suggestions are appreciated.
> >
>
> Per chance are you running lpd ? If so the printer is probably using IRQ 7
> and the module will load fine, but not work. Just a thought.
Hmm. Nope. And besides it works when there's only one 3c900. I'm not
using 3c590s, and the
kernel I'm using is 2.2.17 and Debian.
>
> I run SuSE with no problems with my 2 3c590's.
>
> /Dee
Reply to: