Bug#1018061: pads: segfault at 3a ip

[Tim McConnell <tmcconnell168@gmail.com>]

Hi Bernhard, 
I believe the patch has fixed the issue. I haven't seen any messages
about psad since installing the patch. 
Thanks so much for the fix & patience with me. 

-- 
Tim McConnell <tmcconnell168@gmail.com>


On Wed, 2023-03-15 at 12:10 +0100, Bernhard Übelacker wrote:
> Am 26.02.23 um 16:47 schrieb Tim McConnell:
> 
> > Hi Bernhard,
> > The delay is fine, I'm sure it takes a minute to figure it out ;-)
> > and
> > no I didn't have anything other than defaults for GDB set. I'm not
> > a
> > programmer so I don't know all the tricks to GDB or when is best  
> > to
> > use them. With that said, how would I go about installing /testing
> > the
> > patch you provide? I'm happy to test it out for you, I just need
> > the
> > knowledge of how to.
> > Thanks!
> > 
> 
> 
> Hello Tim,
> if you are fine with installing a bunch of build dependencies
> you could use following steps to rebuild the package with the patch.
> 
> As root:
> # apt build-dep pads
> 
> As user:
> $ mkdir -p source/pads
> 
> Put attached patch to the new directory and continue as user:
> $ cd       source/pads
> $ apt source pads
> $ cd pads-1.2/
> $ patch -p1 < ../pads_print_arp_asset_initialize.patch
> $ dpkg-buildpackage -b
> 
> As root (with the directory adjusted to your user):
> # dpkg -i /home/benutzer/source/pads/{pads_1.2-14_amd64.deb,pads-
> dbgsym_1.2-14_amd64.deb}
> 
> 
> And then see if it still works as expected and see
> if the crash happens again.
> 
> Kind regards,
> Bernhard