Hello gw & Seth
Thanks for your suggestions.
I do not see an interface i can use / have cables for at the memory access panel on the back of my G3.
Gw i have not searched the list (doh!) but i did try to change my xorg.conf settings as i mention in an earlier message.
But this comment about yaboot confused me a bit. Do i have to have matching settings between yaboot and X (how come?)
All the best
Did you look at your xorg config, as Marcin mentioned before?
The graphic settings, via yaboot (or your bootloader), and also xorg.conf have
to be configured properly for the default display(s)
...not sure if either/both apply to your case, but it sounds awefully
There has been a lot of discussion over the last year, on this list, about how
to configure these settings; it should be really helpful then to search /
browse about "black screen" and xorg config issues,
on the website from this mailing list
> On Tue, Oct 28, 2014 at 1:26 PM, Vladimir Berezenko <firstname.lastname@example.org>
> > Hi
> > On Tuesday 28 October 2014 09:01:13, Marcin Spoczyński wrote:
> > > Hi, Which driver are you using ? ...
> > > Try
> > to
> > > look at your xorg config. Maybe it's broken.
> > ...
>> If video=radeonfb:off then
> > graphics is ok, but gui session hangs everythin in some time.
> > --
> > WBR, Vladimir Berezenko.
To UNSUBSCRIBE, email to debian-powerpc-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact email@example.com
Archive: [🔎] firstname.lastname@example.org" target="_blank">https://lists.debian.org/[🔎] email@example.com