Can I install debian on a e300 board?

[Lingfeng Xiong <xionglingfeng@gmail.com>]

hi there.
I got a MPC8313E-RDBB board from Freescale some days before. For I am a 
newbie on PowerPC, I wanna know which toolchain should I use to compile 
software on this board? And can I run debian on this board? If I can, 
how to install debian on SD card and let u-boot load it?

I have tried these steps:
1. Download a business card image for PowerPC architecture from
http://cdimage.debian.org/debian-cd/6.0.1a/powerpc/iso-cd/debian-6.0.1a-powerpc-businesscard.iso
2. Extract Linux kernel from install/powerpc/vmlinux
3. Add u-boot required header by this command (Cygwin):
# ./mkimage.exe -A ppc -O linux -T kernel -C none -a 0x00 -e 0x00 -n 
"Debian-businesscard-squeeze" -d 
../../mpc8313erdbb/debian/businesscard/vmlinux 
../../mpc8313erdbb/debian/businesscard/uImage
Image Name:   Debian-businesscard-squeeze
Created:      Fri Jun  3 19:37:07 2011
Image Type:   PowerPC Linux Kernel Image (uncompressed)
Data Size:    6967555 Bytes = 6804.25 kB = 6.64 MB
Load Address: 0x00000000
Entry Point:  0x00000000

4. Enter u-boot in target board and execute:
U-Boot 1.3.0 (Dec 22 2008 - 11:19:29) MPC83XX

Reset Status:

CPU:   e300c3, MPC8313E, Rev: 21 at 333.333 MHz, CSB:  166 MHz
Board: Freescale MPC8313ERDB
I2C:   ready
DRAM:  128 MB
FLASH:  8 MB
NAND:  32 MiB
In:    serial
Out:   serial
Err:   serial
Net:   TSEC0, TSEC1 [PRIME]
Hit any key to stop autoboot:  0
=>
=> setenv serverip 192.168.0.104
=> dhcp
Speed: 100, full duplex
BOOTP broadcast 1
DHCP client bound to address 192.168.0.103
Using TSEC1 device
TFTP from server 192.168.0.104; our IP address is 192.168.0.103
Filename 'uImage'.
Load address: 0x200000
Loading: 
################################################################# 
  ################################################################# 
     ################################################################# 

################################################################# 
  ################################################################# 
     ################################################################# 

################################################################# 
  ####################
done
Bytes transferred = 6967619 (6a5143 hex)
=> bootm 0x200000
## Booting image at 00200000 ...
   Image Name:   Debian-netinst-squeeze
   Created:      2011-06-03  11:09:45 UTC
   Image Type:   PowerPC Linux Kernel Image (uncompressed)
   Data Size:    6967555 Bytes =  6.6 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
OK

5. System halt here.

Could you tell me which steps I did incorrect and what is the correct 
way? Thanks.
--
创业维艰，缅怀诸先烈。守成不易，莫徒务近功。