[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: eth0 and eth1 mixed



On Sun, 03 Apr 2005 the mental interface of
Tamas K Papp told:

> Sometimes by powerbook boots believing that eth0 is
> 
> eth1394: eth0: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)
> eth1394: eth0: Could not allocate isochronous receive context for the broadcast
> channel
> 
> which makes the network unreachable.  The sungem ethernet port becomes
> eth1.  I googled for the solution, and put
> 
> alias eth0 sungem
> 
> in my modules.conf.  This did not solve the problem, any suggestions?
> It only happens occasionally, but it is annoying.

echo sungem >> /etc/modules

to make sure sungem is loaded before hotplug detects firewire.
Elimar

-- 
  Planung:
  Ersatz des Zufalls durch den Irrtum.
                                -unknown-



Reply to: