Re: IBM RISC600-7248: Boot failure on SCSI: Timeout / Resetting

[Harald Arnold <listen@arnold.at>]

Am Don, 2004-03-18 um 03.09 schrieb Johannes Wischert:
> 
> ----- Original Message ----- 
> From: "Harald Arnold" <listen@arnold.at>
> 
> > When I start on installation process with CD 1 my IBM 7248
> > RISC 6000 with debian V 3.0r2 I always get the same error
> > message repeating till power off:
> >
> > SCSI host 0 abort (pid 4) timeout-resetting
> > SCSI bus is being reset for host 0 channel
> > mcr53c8xx_reset: pid 4
> >   reset_flags=2 serial_number=XXX serial_number of timeout=XXX
> >
> This problem also exists  with my motorola powerstack try to use the
> sym53c8xx driver instead this one works...

OK thanks, but how can I tell debian to use this driver at boot time
of installation process. When starting with CD1 I can't do anything
(I think so) to set an other driver.

Harald