Re: Problems booting pegasos I
On Sat, Nov 06, 2004 at 10:38:37AM +0100, Niklaus Giger wrote:
> Am Freitag, 5. November 2004 23.32 schrieb Sven Luther:
> <...>
> > > I never managed to compile a bootable kernel from the official debian
> > > kernel-source-2.6.8 even when I took a .config from a working kernel made
> > > from the gentoo 2.6.8-pegasos-r2 sources. And I had always the same
> > > problem, that the kernel just never continued after the prom_init.
> >
> > Without the serial log output, not much. It works on my pegasos 1 here.
> >
> Can you tell me the baudrate/parity etc for the serial console. I tried
> various setting but could never found the correct settings. I tried to find
> it by googleing and in various Pegasos forums but couldn't find an answer.
you have to specify it on the kernel line : console=ttyS1,115200n8
Err, that may be console=ttyS01,115200n8 for 2.4 kernels.
115200 no parity 8 bit no flow control (hw or sw) is what the OF uses.
it is active when you disconnect either monitor or keyboard, if i remember
well.
Friendly,
Sven LUther
Reply to: