Connecting to XServe via ieee1394 problems
My last message was a sucess for mounting a VST 6G Firewire Drive on a G4 using 2.4.20 kernel.
Now trying to attach my XServe onto my G4 via firewire. I am not having any luck. I turned off the G4 pluged in the firewire from the xserv (which has been runing from a startup while holding down t) and started the G4 back up and this is what i got.
$ dmesg
.....
ohci1394_0: OHCI-1394 1.0 (PCI): IRQ=[63] MMIO=[80080000-800807ff] Max Packet=[2048]
scsi1 : IEEE-1394 SBP-2 protocol driver (host: ohci1394)
$Rev: 584 $ James Goodwin <jamesg@filanet.com>
SBP-2 module load options:
- Max speed supported: S400
- Max sectors per I/O supported: 255
- Max outstanding commands supported: 8
- Max outstanding commands per lun supported: 1
- Serialized I/O (debug): no
- Exclusive login: yes
ether1394: $Rev: 546 $ Ben Collins <bcollins@debian.org>
ether1394: eth1: IEEE-1394 IPv4 over 1394 Ethernet (ohci1394)
raw1394: /dev/raw1394 device initialized
ieee1394: Host added: Node[00:1023] GUID[00000000fe40eee2] [Linux OHCI-1394]
.....
ieee1394: sbp2: Error logging into SBP-2 device - login timed-out
ieee1394: sbp2: sbp2_login_device failed
ieee1394: Device added: Node[02:1023] GUID[00000000fea68f6c] [AAPL]
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
IN from bad port 3f9 at f2493080
IN from bad port 3f9 at f2493080
IN from bad port 3f9 at f2493080
IN from bad port 2f9 at f2493080
IN from bad port 2f9 at f2493080
IN from bad port 2f9 at f2493080
IN from bad port 3e9 at f2493080
IN from bad port 3e9 at f2493080
IN from bad port 3e9 at f2493080
IN from bad port 2e9 at f2493080
IN from bad port 2e9 at f2493080
IN from bad port 2e9 at f2493080
I am sooooooo glad to be able to connect to my VST but now not much going on with the xserv
-Adam
Reply to: