Re: Kernel 2.4.20-ben7 not booting on my iBook 500

[Claas Langbehn <claas@rootdir.de>]

> Hrm... It's an ATI r128 (M3) based ibook or radeon (M6 or M7) based one ?

it's an ATI r128.

> 
> Can you try adding "printkbtext" to the kernel command line and tell
> me what messages are displayed before the crash and what is the
> exact message displayed last ? Also make sure you do a clean build.

The last messages are about "probing PCI hardware".
I can't really tell which one is the last, because it wraps around
on the bottom of the screen. 

And with ben6 I get a lot of network errors like:

<7>udp v4 hw csum failure.
<7>hm tcp v4 csum failed.


lspci -v of the graphics card:

00:10.0 VGA compatible controller: ATI Technologies Inc Rage Mobility M3
AGP 2x
    (rev 02) (prog-if 00 [VGA])
    Subsystem: ATI Technologies Inc Rage Mobility M3 AGP 2x
    Flags: bus master, stepping, 66Mhz, medium devsel, latency 255, IRQ 48
    Memory at 94000000 (32-bit, prefetchable) [size=64M]
    I/O ports at 802400 [size=256]
    Memory at 90000000 (32-bit, non-prefetchable) [size=16K]
    Expansion ROM at 90020000 [disabled] [size=128K]
    Capabilities: [50] AGP version 2.0
    Capabilities: [5c] Power Management version 2
        


Bye, claas