Re: MIPS kernel snapshots - 2.6.30-rc8
Hello,
On Fri, 2009-09-11 at 13:11 +0100, Martin Michlmayr wrote:
> Do you pass console=duart0 or console=ttyS0 to the kernel? The latter
> is required these days (but that should be the same for linux-mips.git).
> Anyway, I don't have such hardware anymore, so I cannot comment.
Hmm. I wasn't passing that, but then it doesn't seem to be required for
linux-mips.git kernels - just those I get from the Debian project.
After fixing that, it gets farther but still hangs partway through the
boot process:
CFE version 1.3.2 for BCM91480B (64bit,MP,BE,MIPS)
Build Date: Thu Jun 8 09:57:58 PDT 2006 (khinzaw@lc-sj1-091)
Copyright (C) 2000,2001,2002,2003,2004,2005 Broadcom Corporation.
[AREN]
Initializing Arena.
Initializing PCI. [normal]
[PCIH]
PCI[0] bus 0 slot 0/0: configuring bus for 33MHz PCI
[PCIB]
[PCIS]
PCI[0] bus 0 slot 0/0: SiByte, Inc. BCM1480 PCI-X Host Bridge (host
bridge, rev 0x01)
PCI[0] bus 0 slot 1/0: unknown vendor 0x1095 product 0x0680 (RAID mass
storage, rev 0x02)
[PCIH]
HT maxima: 400MHz, 16 bits
[PCIB]
PCI[1] bus 0 slot 0/0: secondary bad or never ready
PCI[1] bus 0 slot 1/0: secondary bad or never ready
[PCIS]
PCI[1] bus 0 slot 0/0: SiByte, Inc. BCM1480 HyperTransport Bridge
(Secondary) (PCI bridge, rev 0x01)
PCI[1] bus 0 slot 1/0: SiByte, Inc. BCM1480 HyperTransport Bridge
(Secondary) (PCI bridge, rev 0x01)
PCI[1] bus 0 slot 2/0: SiByte, Inc. BCM1480 HyperTransport Bridge
(Secondary) (PCI bridge, rev 0x01)
PCI[1] bus 0 slot 4/0: SiByte, Inc. BCM1480 HyperTransport Host Bridge
(host bridge, rev 0x01)
PCI[1] bus 3 slot 1/0: Advanced Micro Devices (PLX) HT7520 PCI-X Tunnel
(PCI bridge, rev 0x12)
PCI[1] bus 3 slot 1/1: Advanced Micro Devices (PLX) HT7520 PCI-X IOAPIC
(8259 PIC system, interface 0x10, rev 0x01)
PCI[1] bus 3 slot 2/0: Advanced Micro Devices (PLX) HT7520 PCI-X Tunnel
(PCI bridge, rev 0x12)
PCI[1] bus 3 slot 2/1: Advanced Micro Devices (PLX) HT7520 PCI-X IOAPIC
(8259 PIC system, interface 0x10, rev 0x01)
[DEVI]
Initializing Devices.
BCM91480B board revision 1
BCM91480B configuration switches: 0xc1010
sbeth: found phy 1, vendor 000818 part 0B
sbeth: found phy 2, vendor 000818 part 0B
sbeth: found phy 3, vendor 000818 part 0B
sbeth: found phy 4, vendor 000818 part 0B
PCIIDE: 1 controllers found
CPU: 1480 B0 (pass2), 4 cpus
L2Cache: 1MB
SysCfg: 0000000040772D00 [PLL_DIV:20, SW_DIV:5, CCNUMA:disable,
IOB_DIV:CPUCLK/4]
Memory controller #0: 250MHz
Memory controller #1: 250MHz
Switch Clock: 400MHz
CPU type 0x1041100: 1000MHz
Total memory: 0x40000000 bytes (1024MB)
Total memory used by CFE: 0x8FE8B000 - 0x8FFFF780 (1525632)
Initialized Data: 0x8FEEBB20 - 0x8FEFABF0 (61648)
BSS Area: 0x8FEFABF0 - 0x8FEFD770 (11136)
Local Heap: 0x8FEFD780 - 0x8FFFD780 (1048576)
Stack Area: 0x8FFFD780 - 0x8FFFF780 (8192)
Text (code) segment: 0x8FE8B000 - 0x8FEEB26A (393834)
Boot area (physical): 0x0FE4A000 - 0x0FE8A000
Relocation Factor: I:F028B000 - D:F028B000
[ENVI]
[CFE ]
CFE> ifconfig eth0 -auto; boot 192.168.1.7:sibyl
sbeth: found phy 1, vendor 000818 part 0B
eth0: Link speed: 1000BaseT FDX
Device eth0: hwaddr 00-02-4C-01-6D-A9, ipaddr 192.168.1.39, mask
255.255.255.0
gateway 192.168.1.1, nameserver 192.168.1.1, domain mshome.net
Loader:raw Filesys:tftp Dev:eth0 File:192.168.1.7:sibyl Options:(null)
Loading: ....... 126648 bytes read
Entry at 0x20000000
Closing network.
Starting program at 0x20000000
[RUN!]
SiByte Loader, version 2.4.2
Built on Jul 28 2004
sbeth: found phy 1, vendor 000818 part 0B
Network device 'eth0' configured
Getting configuration file tftp:192.168.1.7:sibyl.conf...
Config file retrieved.
Available configurations:
debian-nfs
test
gentoo-sda1
gentoo-nfs
debian4-nfs
debian-disk
debian-install
test-nfs
test2-nfs
test3-nfs
test4-nfs
test-disk
test2-disk
test3-disk
clfs
wrs
gentoo-le
gentoo-disk
gentoo-n32
installer
Boot which configuration [debian-nfs]: test
Loading kernel (ELF64):
4925632@0x80100000
done
Set up command line arguments to: root=/dev/nfs console=ttyS0,115200
ip=any nfsroot=192.168.1.7:/home/mason/debian-root
Setting up initial prom_init arguments
Cleaning up state...
Transferring control to the kernel.
Kernel entry point is at 0x80106150
Linux version 2.6.31-rc9-00013-gfb43039 (mason@linux-7kdl) (gcc version
3.4.3) #29 SMP Wed Sep 9 20:23:47 PDT 2009
console [early0] enabled
CPU revision is: 01041100 (SiByte SB1A)
FPU revision is: 000f0103
Checking for the multiply/shift bug... no.
Checking for the daddiu bug... no.
Broadcom SiByte BCM1480 B0 (pass2) @ 1000 MHz (SB-1A rev 0)
Board type: SiByte BCM91x80A/B (BigSur)
Determined physical RAM map:
memory: 000000000fe8ae00 @ 0000000000000000 (usable)
memory: 000000001ffffe00 @ 0000000080000000 (usable)
memory: 000000000ffffe00 @ 00000000c0000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
DMA32 0x00000000 -> 0x00100000
Normal 0x00100000 -> 0x00100000
Movable zone start PFN for each node
early_node_map[3] active PFN ranges
0: 0x00000000 -> 0x0000fe8a
0: 0x00080000 -> 0x0009ffff
0: 0x000c0000 -> 0x000cffff
[CPU1]
[cpu1]
[CPU2]
[cpu2]
[CPU3]
Detected 3 available secondary CPU(s)
cBuilt 1 zonelists in Zone order, mobility grouping on. Total pages:
250120
Kernel command line: root=/dev/nfs console=ttyS0,115200 ip=any
nfsroot=192.168.1.7:/home/mason/debian-root
PID hash table entries: 4096 (order: 12, 32768 bytes)
Dentry cache hash table entries: 131072 (order: 8, 1048576 bytes)
Inode-cache hash table entries: 65536 (order: 7, 524288 bytes)
Primary instruction cache 32kB, VIVT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
Memory: 991868k/1047072k available (3526k kernel code, 54400k reserved,
1015k data, 268k init, 0k highmem)
NR_IRQS:128
Calibrating delay loop... 663.55 BogoMIPS (lpj=331776)
Mount-cache hash table entries: 256
Checking for the daddi bug... no.
CPU revision is: 03041100 (SiByte SB1A)
FPU revision is: 000f0103
Primary instruction cache 32kB, VIVT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
Calibrating delay loop... 665.60 BogoMIPS (lpj=332800)
CPU revision is: 05041100 (SiByte SB1A)
FPU revision is: 000f0103
Primary instruction cache 32kB, VIVT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
Calibrating delay loop... 665.60 BogoMIPS (lpj=332800)
CPU revision is: 07041100 (SiByte SB1A)
FPU revision is: 000f0103
Primary instruction cache 32kB, VIVT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
Calibrating delay loop... 665.60 BogoMIPS (lpj=332800)
Brought up 4 CPUs
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
SCSI subsystem initialized
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 6, 262144 bytes)
TCP established hash table entries: 131072 (order: 9, 2097152 bytes)
TCP bind hash table entries: 65536 (order: 8, 1048576 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
NET: Registered protocol family 1
audit: initializing netlink socket (disabled)
type=2000 audit(6220878072.154:1): initialized
VFS: Disk quotas dquot_6.5.2
Dquot-cache hash table entries: 512 (order 0, 4096 bytes)
msgmni has been set to 1938
alg: No test for cipher_null (cipher_null-generic)
alg: No test for ecb(cipher_null) (ecb-cipher_null)
alg: No test for digest_null (digest_null-generic)
alg: No test for compress_null (compress_null-generic)
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
pci 0001:03:01.0: AMD8131 rev 12 detected; disabling PCI-X MMRBC
pci 0001:03:02.0: AMD8131 rev 12 detected; disabling PCI-X MMRBC
Reply to: