RE: kernel newer than 2.6.17 on qube
You wrote;
> Furthermore, I've updated my Debian on Cobalt installation
> page yesterday to describe the installation of etch rather
> than sarge, see http://www.cyrius.com/debian/cobalt/install.html
> --
Martin,
For some reason the RaQ (RaQ2+) hangs at 'Net Booting'
Below is the console port output;
====================== console output ======================
Cobalt Microserver Diagnostics - 'We serve it, you surf it'
Built Wed Mar 3 21:26:25 PST 1999
1.LCD Test................................PASS
2.Controller Test.........................PASS
5.Bank 0:.................................64M
6.Bank 1:.................................64M
7.Bank 2:.................................0M
8.Bank 3:.................................0M
9.Serial Test.............................PASS
10.PCI Expansion Slot....................**EMPTY**
12.IDE Test................................PASS
13.Ethernet Test...........................PASS
16.RTC Test................................PASS
Decompressing done
Jump_to_Real_Kernel: disk error, trying BFD again
BOOTLOADER DEBUG: flashdelaying..
=============================================================
I have a CacheRaQ2 with the 2.4 kernel acting as the dhcp/nfs server.
Address 192.168.1.55 eth0
Listening 192.168.0.0 eth1
When I boot the RaQ2+ using dhcp it gets address from dhcp/nfs server.
This was a test to see if the RaQ2+ could get IP config from dhcp/nfs
server.
Ideas?
TIA
Gerald
Reply to: