Re: debian-mips 3.1on O2, arcboot: IO error, arcboot: no such device
Thiemo Seufer wrote:
> os junkie wrote:
> > Good evening all,
> > I'm trying to load debian (3.1R4) on an SGI O2 with 64MB.
> > The TFTP boot works like a charm, net install goes exactly as expected,
> > but after all is said and done, when I reboot and enter my 4
> > "setenv..." lines, I get the following error:
> > SCSI Hard Error on (0,1) unexpected bus free (hastat 0x13) --check
> > cabling
> > cbd: 12 0 0 0 1 0
> > <above line occurs 5 times, identical, then the next errors:>
> > Unable to execute scsi(0)disk(1)rdisk(0)partition(8)/arcboot: IO error
> > Unable to load scsi(0)disk(1)rdisk(0)partition(8)/arcboot: no such
> > device.
> > I've done the load twice, just in case I typo'd somewhere, with the
> > exact same results. My setenv lines were taken from the closing
> > instructions in the load and are as follows:
> > setenv SystemPartition scsi(0)disk(1)rdisk(0)partition(8)
> > setenv OSLoadPartition scsi(0)disk(1)rdisk(0)partition(0)
> I think this should be prefixed with the pci spec:
> setenv SystemPartition pci(0)scsi(0)disk(1)rdisk(0)partition(8)
> setenv OSLoadPartition pci(0)scsi(0)disk(1)rdisk(0)partition(0)
I'll give that a try and post back.