|
Hello, I’m new to the list and not familiar with cobalt raqs, I saw it was possible to install a sarge on it, so I’m trying …
I have read a howto on installing sarge on a cobalt raq or cube (http://www.cyrius.com/debian/cobalt/sarge.html), but I can’t make it work on a raq 550. Can someone confirm that this howto is applicable or not to a raq 550 ? I’ve searched the archive list but didn’t found anything confirming this, and how !
if the raq is set to bfn via nfs :
IP-Config: Got DHCP answer from 192.168.1.130, my address is 192.168.1.125 IP-Config: Complete: device=eth0, addr=192.168.1.125, mask=255.255.255.0, gw=192.168.1.1, host=cobalt, domain=, nis-domain=(none), bootserver=192.168.1.130, rootserver=192.168.1.130, rootpath=/nfsroot NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. Looking up port of RPC 100003/2 on 192.168.1.130 Looking up port of RPC 100005/1 on 192.168.1.130 VFS: Mounted root (nfs filesystem). Freeing unused kernel memory: 112k freed Warning: unable to open an initial console. Kernel panic: No init found. Try passing init= option to kernel. <6>disabling network interfaces.
And with cobalt set_boot_type to netkernel (set in the boot section of the bios of the raq) :
BOOTLOADER: opening "/boot/vmlinux.gz" BOOTLOADER: reading "/boot/vmlinux.gz" BOOTLOADER: read 55646bytes BOOTLOADER: unmounting / BOOTLOADER: calling reboot notifiers md: stopping all md devices. flushing ide devices: hda disabling network interfaces. BOOTLOADER: mapping 22M-32M for ride home BOOTLOADER: disabling interupts BOOTLOADER: flushing cache BOOTLOADER: Leap of faith! Back in ramcode: done Second stage kernel: Decompressing -Error bunzip2ing kernel. Trying gunzip. - done
and it then reboot :
command line: 'console=ttyS0,115200 debug ip=on root=/dev/nfs nfsroot=192.168.1. 130:/nfsroot-x86,rsize=8192,wsize=8192 ' booting kernel...
DIMM 0, RxCxB, Size/Index = DxAx4, 1x256MB/8, OK DIMM 1, none found DIMM 2, none found DIMM 3, none found)
Thank you,
Renaud |