Re: Installing Debian sarge (beta4) on Cobalt
> Can you try the new images from
> http://people.debian.org/~tbm/d-i/images/mipsel/daily/cobalt/netboot/
> and see if they work for you?
Thanks for the fast response! I tried the new images, without additional
kernel parameters. The segmentation fault doesn't come up anymore,
but the second problem continues:
Like before, the installation process runs up to the partitioner.
The disk is prepartitioned, so I just have to set the filesystems and mount points:
#1 primary 23.1 MB B F extr0 /boot
#2 primary 131.6 MB K swap swap
#3 primary 5.9 GB f ext3 /
#4 primary 3.9 GB F ext3 /home
After selecting "write to disk", install hangs by the message
"Creating ext3 filesystem for / in partition #3 of IDE master (hda) ...".
The process bar shows "0%" and does not move, I waited half an hour.
A second try showed the same results.
What can I do?
Thanks!
--
Pepillo
Reply to: