Re: switched from autotools to waf

[Jaromír Mikeš <mira.mikes@seznam.cz>]

> Od: Paul Wise <pabs@debian.org>

> I think it is fairly obvious that you need to remove the *.pyc file in
> the debian/rules clean target.

Thank you Paul a lot it works.
Now during package build having this error:

# Add here commands to clean up after the build process.
./waf distclean
distclean finished successfully
rm -f config.sub config.guess autowaf.pyc
dh_clean 
 dpkg-source -b slv2-0.6.2
dpkg-source: info: using source format `1.0'
dpkg-source: info: building slv2 using existing slv2_0.6.2.orig.tar.gz
dpkg-source: info: building slv2 in slv2_0.6.2-1.diff.gz
dpkg-source: info: building slv2 in slv2_0.6.2-1.dsc
 debian/rules build
make: *** No rule to make target `configure', needed by `config.status'.  Stop.
dpkg-buildpackage: failure: debian/rules build gave error exit status 2
pbuilder: Failed autobuilding of package

I tried change ./configure to $(WAF) configure on line 34 in my debian/rules, but I got same result.

regards

mira