Re: SMC2835W with Ubuntu

[Kiss Tamás <kiss@dsr.hu>]

Joris wrote:
> > [4294991.502000] ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNKA] -> 
> > GSI 11 (level, low) -> IRQ 11
> > [4294991.503000] eth1: uploading firmware...
> > [4294991.586000] eth1: firmware version: 1.0.4.3
> > [4294991.586000] eth1: firmware upload complete
> > [4294991.756000] eth1: resetting device...
> > [4294991.756000] eth1: uploading firmware...
> > [4294991.841000] eth1: firmware version: 1.0.4.3
> > [4294991.841000] eth1: firmware upload complete
> > [4294992.841000] eth1: no 'reset complete' IRQ seen - retrying
> > [4294993.841000] eth1: no 'reset complete' IRQ seen - retrying
> > [4294993.841000] eth1: interface reset failure
> > [4294993.841000] prism54: Your card/socket may be faulty, or IRQ line 
> > too busy :(
> >     
>
> try adding pci=noacpi to your kernel command line.
> if you are using grub, edit /boot/grub/menu.lst at the line starting
> with '# kopt='. run 'sudo update-grub' afterwards to propagate it to the
> actual kernel parameters.
> good luck,
>
>   
I done this ... u can see dmseg log bottom of mail. Nothing change.
ACPI is disable in this time (3th line) ...

4296223.341000] eth1: hot unplug detected
[4296223.341000] eth1: removing device
[4296223.348000] ACPI: PCI interrupt for device 0000:03:00.0 disabled
[4296228.899000] pccard: CardBus card inserted into slot 0
[4296228.899000] PCI: Enabling device 0000:03:00.0 (0000 -> 0002)
[4296228.899000] ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNKA] -> 
GSI 11 (level, low) -> IRQ 11
[4296228.900000] eth1: uploading firmware...
[4296228.983000] eth1: firmware version: 1.0.4.3
[4296228.983000] eth1: firmware upload complete