how to post--configure the Xserver, (XF86Setup or the alike)
Hello
After having installed Knoppix 3.3 on my Laptop, and upgrading to SID,
I tried to connect a cordless Logitech mouse, via the USB
port. However it is not detected my the Xserver. When I boot from the
Knoppix CD again, it is detected, but of course I don't want to redo
the installation. I could try to edit the X86Config file, but I
remember from my earlie SuSe days, that there was a GUI (XF86Setup or
something like this) which allows me a configuration without editing
the XF86Config file.
is there anything like this available, I searched the package dir
without success.
thanks
Uwe Brauer
Reply to: