Re: compaq nx9010
Incoming from Ryoji Takahashi:
>
> i've just got compaq nx9010 from our institute. I'm now currently
> installing debian woody-3.0r0.
>
> But, if someone knows, i would like get information about MBR ... after
> i installed, i edited lilo.config ... i checked lilo. Then it seems i
> didn't mistake though, then, there is no boot manager comes out. I
After editing lilo.conf, you have to run lilo for it to take effect.
If you made a boot floppy, you can boot off that, run lilo, then boot
from the hard drive.
If it boots up from lilo, you can press the <SHIFT> key when you see
the lilo prompt. That will list your possible boot options.
--
Any technology distinguishable from magic is insufficiently advanced.
(*) http://www.spots.ab.ca/~keeling
- -
Reply to: