|
Hi i’m desperate! i like to connect to the inet but connection
fails: message reads: eth0: unknown interface:
no such device pppoe: ioctl(SIOCIFHWADDR): No such devide in KDE2.2 is an application: ADSL/PPPOE configuration: it tells that it found 1 ethernet
device: tap0 or tap() = more likely and I con load card drivers manually what I do: I select net I select sis900 - SiS 900/7016 PCI Fast Ethernet Adapter support yes to “Install this in kernel?” I write in
command-line: AUTO_CONFIG (I also left it empty! some other time!) message: /lib/modules/2.2.20/net/sis900.o:
init_module: Divice or
resource busy Hint: insmod errors can be caused by incorrect module parameters,
including invalid IO or IRQ parameters /lib/modules/2.2.20/net/sis900.o:
insmod /lib/modules/2.2.20/net/sis900.o failed /lib/modules/2.2.20/net/sis900.o:
insmod sis900 failed Installation failed. What now? I didn’t
find out! before I used W2K prof and here is the installation stuff: Double click "SiS
900 PCI Fast Ethernet Adapter" then a properties page appears. 5. Click "Advanced" tab. 6. Here, you can set the following properties:
<1>. EthernetMediaType
100BaseTX
100BaseTX Full_Duplex
10BaseT Full_Duplex
10BaseT
AUTO_CONFIG ;Default value if not set
<2>. NetworkAddress
Override the adapter's Ethernet address. Legal values are
xx-xx-xx-xx-xx-xx, where xx is a hexadecimal
byte value.
Unless necessary, do NOT modify this field and let the
system use the default Ethernet address
contained in the
serial ROM on the adapter. Please help me! Manfred |