Re: Pcmcia-HOWTO: Dudes, questions and suggestions [solutioned]
Hola,
la unica cosa que no probe:
the only thing that i don't test:
modprobe 8139too
la tarjeta y la red ya esta funcionando.
Card and net yet are working.
Salud y Revolución.
Lobo.
-------- Original Message --------
On Wed, Oct 09, 2002 at 02:29:14AM +0200, Rubén Gómez Antolí wrote:
>
> Oct 8 20:41:50 Puerto_Lobo cardmgr[1217]: socket 1: CardBus hotplug device
Everything is working fine. Your card was configured correctly.
With 2.4 kernel PCMCIA support, CardBus cards like this are configured
by the linux-hotplug subsystem, not by cardmgr. Cardmgr just notes
that the card is a hotplug device and does nothing.
You should configure your kernel to build the Realtek PCI network
driver, 8139too, as a module. If you modprobe that driver after
inserting your card, you should get some messages in your system log
saying that the eth0 interface is available. The linux-hotplug
scripts should be able to load the driver automatically if you have
current ones. You also need to have CONFIG_HOTPLUG enabled in your
kernel.
-- Dave
--
Libertad es poder elegir en cualquier momento. Ahora yo eligo GNU/Linux,
para no atar mis manos con las cadenas del soft propietario.
Reply to: