Tecra 8100 networking
I just recently reinstalled Woody on my T8100. The first time, I
installed using a port replicator. After install, when I booted the
machine on the port replicator, it would find the interface and assign
the IP address. When I was using the PCMCIA NIC (a Xircom RealPort 16),
I had to manually start restart pcmcia.
After the rebuild (which I did using the PCMCIA NIC), the box comes up
normally when using PCMCIA, but when on the port replicator, I have to
do ifcfg eth0 to get the NIC in the replicator up and running. How can I
get either nic up and running automagically?
Thanks,
--
--Brad
============================================================================
Bradley M. Alexander | storm [at] debian.org
Debian Developer, Security Engineer | storm [at] tux.org
Debian/GNU Linux Developer | Visit the 99th VFS website at:
99th VFS 'Tuskegee Airmen' | http://99thvfs-ta.org
============================================================================
Key fingerprints:
DSA 0x54434E65: 37F6 BCA6 621D 920C E02E E3C8 73B2 C019 5443 4E65
RSA 0xC3BCBA91: 3F 0E 26 C1 90 14 AD 0A C8 9C F0 93 75 A0 01 34
============================================================================
In case of emergency, break glass. Scream. Bleed to death.
Reply to: