Re: eth0 (Xircon) does not exist
On Wed, Dec 20, 2000 at 05:31:15PM +0100, Alberto Bigazzi wrote:
>
> Dear all,
>
> I've got a pcmcia ethernet+modem card which I'm trying hard to setup with
> very poor outcome:
>
> > ifconfig eth0
> eth0: error fetching interface information: Device not found
>
> Here is some debug output.
> Does anyone out there see what I'm doing wrong?
>
> Thanks very much.
> Alberto.
>
> =========================== Debug info =========================
> >lsmod
>
> Module Size Used by
> serial_cs 5376 0 (unused)
> ds 6536 2 [serial_cs]
> i82365 28516 2
> pcmcia_core 44416 0 [serial_cs ds i82365]
modprobe yenta_socket?
>
> > cardctl config
>
> Socket 0:
> Vcc 5.0V Vpp1 0.0V Vpp2 0.0V
> interface type is "memory and I/O"
> irq 3 [exclusive] [level]
> Speaker output is enabled
> function 0:
> config base 0x0800
> option 0x61 status 0x08
> io 0x13f8-0x13ff [8bit]
> Socket 1:
> not configured
>
> > cardctl info
>
> Socket 0:
> product info: "Xircom", "CreditCard Ethernet+Modem II", "CEM2", "1.00"
> manfid: 0x0105, 0x110a
> function: 2 (serial)
> Socket 1:
> no product info available
>
>
> > cat /var/run/stab
>
> Socket 0: Xircom CE II Ethernet/Modem
> 0 serial serial_cs 0 ttyS2 4 66
> Socket 1: empty
--xsdg
--
___________________________________________________
/ Hildebrant's Principle: If you don't know where \
\ you are going, any road will get you there. /
/ http://xsdg.hypermart.net|xsdg@softhome.net \
\___________________________________________________/
Reply to: