Re: [debian-knoppix] HotPlug / My fstab problem?
Hello,
thanks for answering :)
> Usually you should see something like this:
>
> Jul 18 11:10:39 Skeeve kernel: usb.c: USB device 7 (vend/prod 0x67b/0x2507) is
> not claimed by any active driver.
> Jul 18 11:10:45 Skeeve kernel: Initializing USB Mass Storage driver...
> Jul 18 11:10:45 Skeeve kernel: usb.c: registered new driver usb-storage
> Jul 18 11:10:45 Skeeve kernel: scsi1 : SCSI emulation for USB Mass Storage
> devices
> Jul 18 11:10:45 Skeeve kernel: usb-uhci.c: interrupt, status 3, frame# 2040
> Jul 18 11:10:45 Skeeve kernel: Vendor: TOSHIBA Model: MK6021GAS
> Rev: GA02
> Jul 18 11:10:45 Skeeve kernel: Type: Direct-Access
> ANSI SCSI revision: 02
> Jul 18 11:10:45 Skeeve kernel: Attached scsi disk sda at scsi1, channel 0, id
> 0, lun 0
> Jul 18 11:10:45 Skeeve kernel: SCSI device sda: 117210241 512-byte hdwr
> sectors (60012 MB)
> Jul 18 11:10:45 Skeeve kernel: sda: sda1
> Jul 18 11:10:45 Skeeve kernel: USB Mass Storage support registered.
I never saw that... Where should I see that? Is it when I plug something?
>
> It has to look something like this:
> "/dev/sda1 /mnt/usb auto auto,users 0 0"
On the forum, they said me that I had to write that in the fstab:
> > none /proc/bus/usb usbdevfs defaults 0 0
which is very different from the one you gave me. But which on is good then? :(
Or do I need to write both in my FSTAB?
Thxs helping me!
Ludo
_______________________________________________
debian-knoppix mailing list
debian-knoppix@linuxtag.org
http://mailman.linuxtag.org/mailman/listinfo/debian-knoppix
Reply to: