Bug#1067858: reset SuperSpeed USB device number 2 using xhci_hcd
Source: linux-signed-amd64
Version: 6.7.9+2
Severity: normal
X-Debbugs-CC: pierretom+12@ik.me
Dear Maintainer,
Since kernel 6.7.7-1 to 6.7.9+2 (amd64), I got this message when turning on the external drive.
The device is accessible after about 1 minute, then I can mount it and access data.
Does not happen on kernel 6.6.15+2 and prior versions.
SATA/USB controller: Bus 006 Device 003: ID 174c:5106 ASMedia Technology Inc. ASM1051 SATA 3Gb/s bridge
SATA controler: ASMedia Technology Inc. ASM1061/ASM1062 Serial ATA Controller (rev 01)
# dmesg
[ 89.821220] usb 6-1: new SuperSpeed USB device number 2 using xhci_hcd
[ 98.669813] usb 6-1: New USB device found, idVendor=174c, idProduct=5106, bcdDevice= 0.01
[ 98.669829] usb 6-1: New USB device strings: Mfr=2, Product=3, SerialNumber=1
[ 98.669836] usb 6-1: Product: AS2105
[ 98.669842] usb 6-1: Manufacturer: ASMedia
[ 98.669847] usb 6-1: SerialNumber: XXXXXXXX
[ 98.702925] usb-storage 6-1:1.0: USB Mass Storage device detected
[ 98.703186] scsi host10: usb-storage 6-1:1.0
[ 98.703323] usbcore: registered new interface driver usb-storage
[ 98.712000] usbcore: registered new interface driver uas
[ 99.729263] scsi 10:0:0:0: Direct-Access ST3000DM 001-1CH166 CC29 PQ: 0 ANSI: 0
[ 99.729842] sd 10:0:0:0: Attached scsi generic sg3 type 0
[ 99.730034] sd 10:0:0:0: [sdc] Very big device. Trying to use READ CAPACITY(16).
[ 130.381128] usb 6-1: reset SuperSpeed USB device number 2 using xhci_hcd
[ 130.401814] sd 10:0:0:0: [sdc] 5860533168 512-byte logical blocks: (3.00 TB/2.73 TiB)
[ 130.402173] sd 10:0:0:0: [sdc] Write Protect is off
[ 130.402181] sd 10:0:0:0: [sdc] Mode Sense: 23 00 00 00
[ 130.402486] sd 10:0:0:0: [sdc] No Caching mode page found
[ 130.402493] sd 10:0:0:0: [sdc] Assuming drive cache: write through
[ 130.403339] sd 10:0:0:0: [sdc] Very big device. Trying to use READ CAPACITY(16).
[ 161.100747] usb 6-1: reset SuperSpeed USB device number 2 using xhci_hcd
[ 161.395030] sdc: sdc1 sdc2
[ 161.395511] sd 10:0:0:0: [sdc] Attached SCSI disk
Reply to: