Bug#925204: linux-image-4.19.0-2-amd64: Using USB 3.0 interface in VMWare and UAS device is not working
Package: linux-image-amd64
Version: 4.19+102
Severity: important
Hi,
The UAS device drivers are not working under VMWare. I have to use a work
around and blacklist the UAS driver to get device working.
This is the output of dmesg before blacklisting and after:
[18853.525588] usb 4-1: new SuperSpeed Gen 1 USB device number 2 using xhci_hcd
[18853.555794] usb 4-1: New USB device found, idVendor=152d, idProduct=3562,
bcdDevice=63.02
[18853.555797] usb 4-1: New USB device strings: Mfr=1, Product=2,
SerialNumber=3
[18853.555799] usb 4-1: Product: AD TO BE II
[18853.555800] usb 4-1: Manufacturer: ADMKIV
[18853.555802] usb 4-1: SerialNumber: DB1234567897B0
[18853.618227] usbcore: registered new interface driver usb-storage
[18853.630722] scsi host3: uas
[18853.631660] usbcore: registered new interface driver uas
[18853.634778] usb 4-1: stat urb: status -32
[18853.634836] scsi 3:0:0:0: tag#4 data cmplt err -32 uas-tag 1 inflight: CMD
[18853.634839] scsi 3:0:0:0: tag#4 CDB: Inquiry 12 00 00 00 24 00
[18874.274509] scsi 3:0:0:0: tag#4 uas_eh_abort_handler 0 uas-tag 1 inflight:
CMD
[18874.274517] scsi 3:0:0:0: tag#4 CDB: Inquiry 12 00 00 00 24 00
[18874.299065] scsi host3: uas_eh_device_reset_handler start
[18874.436689] usb 4-1: reset SuperSpeed Gen 1 USB device number 2 using
xhci_hcd
[18874.471991] scsi host3: uas_eh_device_reset_handler success
[18874.474250] usb 4-1: stat urb: status -32
[18874.475158] scsi 3:0:0:0: tag#4 uas_eh_abort_handler 0 uas-tag 1 inflight:
CMD
[18874.475182] scsi 3:0:0:0: tag#4 CDB: Test Unit Ready 00 00 00 00 00 00
[18874.475190] scsi host3: uas_eh_device_reset_handler start
[18874.718701] usb 4-1: reset SuperSpeed Gen 1 USB device number 2 using
xhci_hcd
[18874.747546] scsi host3: uas_eh_device_reset_handler success
[18874.747552] scsi 3:0:0:0: Device offlined - not ready after error recovery
[18899.867372] usbcore: deregistering interface driver uas
[18910.834000] usbcore: deregistering interface driver usb-storage
[18914.787331] usb 4-1: UAS is blacklisted for this device, using usb-storage
instead
[18914.787333] usb-storage 4-1:1.0: USB Mass Storage device detected
[18914.788277] usb-storage 4-1:1.0: Quirks match for vid 152d pid 3562: 800000
[18914.788371] scsi host3: usb-storage 4-1:1.0
[18914.788721] usbcore: registered new interface driver usb-storage
[18915.795385] scsi 3:0:0:0: Direct-Access ADplus SuperVer 6302
PQ: 0 ANSI: 6
[18915.796367] scsi 3:0:0:0: Attached scsi generic sg1 type 0
[18915.816273] sd 3:0:0:0: [sda] 1953525168 512-byte logical blocks: (1.00
TB/932 GiB)
[18915.817608] sd 3:0:0:0: [sda] Write Protect is off
[18915.817612] sd 3:0:0:0: [sda] Mode Sense: 33 00 00 08
[18915.820683] sd 3:0:0:0: [sda] No Caching mode page found
[18915.820690] sd 3:0:0:0: [sda] Assuming drive cache: write through
[18915.827904] sda: sda1 sda2 sda3
[18915.834691] sd 3:0:0:0: [sda] Attached SCSI disk
-- System Information:
Debian Release: buster
APT prefers testing
APT policy: (500, 'testing')
Architecture: amd64 (x86_64)
Foreign Architectures: i386
Kernel: Linux 4.19.0-2-amd64 (SMP w/4 CPU cores)
Kernel taint flags: TAINT_OOT_MODULE, TAINT_UNSIGNED_MODULE
Locale: LANG=ro_RO.UTF-8, LC_CTYPE=ro_RO.UTF-8 (charmap=UTF-8), LANGUAGE=en_US:ro (charmap=UTF-8)
Shell: /bin/sh linked to /bin/dash
Init: systemd (via /run/systemd/system)
LSM: AppArmor: enabled
Versions of packages linux-image-amd64 depends on:
ii linux-image-4.19.0-2-amd64 4.19.16-1
linux-image-amd64 recommends no packages.
linux-image-amd64 suggests no packages.
-- no debconf information
Reply to: