I created a 4T dataset to use in a debian server as hdd backup. I have open-iscsi installed on debian and working correctly, but after logging in (iscsiadm -m node --targetname...), I can not see the 4T dataset (/dev/sdc).
fdisk -l shows only sda and sdb, both of 1TB that I had already set up some time ago.
Debian dmesg shows:
[ 5266.620369] sd 7:0:0:4: [sdc] READ CAPACITY(16) failed
[ 5266.620373] sd 7:0:0:4: [sdc]
[ 5266.620375] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
[ 5266.620378] sd 7:0:0:4: [sdc]
[ 5266.620380] Sense Key : Not Ready [current]
[ 5266.620383] sd 7:0:0:4: [sdc]
[ 5266.620386] Add. Sense: Logical unit not ready, manual intervention required
[ 5266.621129] sd 7:0:0:4: [sdc] READ CAPACITY failed
[ 5266.621136] sd 7:0:0:4: [sdc]
[ 5266.621143] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
[ 5266.621147] sd 7:0:0:4: [sdc]
[ 5266.621150] Sense Key : Not Ready [current]
[ 5266.621154] sd 7:0:0:4: [sdc]
[ 5266.621158] Add. Sense: Logical unit not ready, manual intervention required
[ 5266.622251] sd 7:0:0:4: [sdc] Write Protect is off
[ 5266.622256] sd 7:0:0:4: [sdc] Mode Sense: 73 00 10 08
[ 5266.622667] sd 7:0:0:4: [sdc] Write cache: enabled, read cache: enabled, supports DPO and FUA
[ 5266.625062] sd 7:0:0:4: [sdc] READ CAPACITY(16) failed
[ 5266.625066] sd 7:0:0:4: [sdc]
[ 5266.625068] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
[ 5266.625070] sd 7:0:0:4: [sdc]
[ 5266.625072] Sense Key : Not Ready [current]
[ 5266.625076] sd 7:0:0:4: [sdc]
[ 5266.625078] Add. Sense: Logical unit not ready, manual intervention required
[ 5266.625817] sd 7:0:0:4: [sdc] READ CAPACITY failed
[ 5266.625823] sd 7:0:0:4: [sdc]
[ 5266.625826] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
[ 5266.625830] sd 7:0:0:4: [sdc]
[ 5266.625832] Sense Key : Not Ready [current]
[ 5266.625837] sd 7:0:0:4: [sdc]
[ 5266.625842] Add. Sense: Logical unit not ready, manual intervention required
[ 5266.627836] sd 7:0:0:4: [sdc] Attached SCSI disk
Any idea about the problem?
--
Elias Pereira