Bug#794266: linux-image-4.0.0-2-kirkwood: Shutdown results in reboot
Package: src:linux
Version: 4.0.8-2
Severity: important
Dear Maintainer,
Any attempt to shutdown (sytemctl poweroff, shutdown now -h, poweoff, ...) results in system reboot.
I am experiencing this with both 3.16 an 4.0.0.
Best regards
Mike
-- Package-specific info:
** Kernel log: boot messages should be attached
** Model information
Hardware : QNAP TS-41x
Revision : 0000
** Network interface configuration:
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
#The following two lines are for dhcp
allow-hotplug eth0
#iface eth0 inet dhcp
#The following lines are for static ip address
iface eth0 inet static
address 192.168.2.101
netmask 255.255.255.0
gateway 192.168.2.1
# The secondary network interface
# (configured as static for rescue purposes)
auto eth1
iface eth1 inet static
address 10.0.0.6
netmask 255.255.255.0
** PCI devices:
00:00.0 Host bridge [0600]: Marvell Technology Group Ltd. Device [11ab:6282] (rev 01)
Subsystem: Marvell Technology Group Ltd. Device [11ab:11ab]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 9
Region 0: Memory at <ignored> (64-bit, prefetchable)
Capabilities: <access denied>
00:01.0 SCSI storage controller [0100]: Marvell Technology Group Ltd. 88SX7042 PCI-e 4-port SATA-II [11ab:7042] (rev 02)
Subsystem: Marvell Technology Group Ltd. Device [11ab:11ab]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 9
Region 0: Memory at e0000000 (64-bit, non-prefetchable) [size=1M]
Region 2: I/O ports at 1000 [size=256]
Capabilities: <access denied>
Kernel driver in use: sata_mv
01:00.0 Host bridge [0600]: Marvell Technology Group Ltd. Device [11ab:6282] (rev 01)
Subsystem: Marvell Technology Group Ltd. Device [11ab:11ab]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 10
Region 0: Memory at <ignored> (64-bit, prefetchable)
Capabilities: <access denied>
01:01.0 USB controller [0c03]: Etron Technology, Inc. EJ168 USB 3.0 Host Controller [1b6f:7023] (rev 01) (prog-if 30 [XHCI])
Subsystem: Etron Technology, Inc. EJ168 USB 3.0 Host Controller [1b6f:7023]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 10
Region 0: Memory at e8000000 (64-bit, non-prefetchable) [size=32K]
Capabilities: <access denied>
Kernel driver in use: xhci_hcd
** USB devices:
Bus 003 Device 002: ID 05e3:0608 Genesys Logic, Inc. USB-2.0 4-Port HUB
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
-- System Information:
Debian Release: stretch/sid
APT prefers testing
APT policy: (500, 'testing')
Architecture: armel (armv5tel)
Kernel: Linux 3.16.0-4-kirkwood
Locale: LANG=en_US.UTF-8, LC_CTYPE=en_US.UTF-8 (charmap=UTF-8)
Shell: /bin/sh linked to /bin/dash
Init: systemd (via /run/systemd/system)
Versions of packages linux-image-4.0.0-2-kirkwood depends on:
ii debconf [debconf-2.0] 1.5.57
ii initramfs-tools [linux-initramfs-tool] 0.120
ii kmod 21-1
ii linux-base 3.5
Versions of packages linux-image-4.0.0-2-kirkwood recommends:
ii firmware-linux-free 3.3
ii uboot-mkimage 2012.04.01-2
Versions of packages linux-image-4.0.0-2-kirkwood suggests:
pn debian-kernel-handbook <none>
pn fdutils <none>
pn linux-doc-4.0 <none>
Versions of packages linux-image-4.0.0-2-kirkwood is related to:
pn firmware-atheros <none>
pn firmware-bnx2 <none>
pn firmware-bnx2x <none>
pn firmware-brcm80211 <none>
pn firmware-intelwimax <none>
pn firmware-ipw2x00 <none>
pn firmware-ivtv <none>
pn firmware-iwlwifi <none>
pn firmware-libertas <none>
pn firmware-linux <none>
pn firmware-linux-nonfree <none>
pn firmware-myricom <none>
pn firmware-netxen <none>
pn firmware-qlogic <none>
pn firmware-ralink <none>
pn firmware-realtek <none>
pn xen-hypervisor <none>
-- debconf information:
linux-image-4.0.0-2-kirkwood/postinst/mips-initrd-4.0.0-2-kirkwood:
linux-image-4.0.0-2-kirkwood/postinst/depmod-error-initrd-4.0.0-2-kirkwood: false
linux-image-4.0.0-2-kirkwood/prerm/removing-running-kernel-4.0.0-2-kirkwood: true
Reply to: