[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#595223: marked as done (linux-image-2.6-xen-amd64: channel scanning with b2c2-flexcop-pci)

Your message dated Sat, 8 Jun 2013 12:16:55 +0200
with message-id <20130608101655.GE4796@pisco.westfalen.local>
and subject line Closing
has caused the Debian Bug report #595223,
regarding linux-image-2.6-xen-amd64: channel scanning with b2c2-flexcop-pci
to be marked as done.

This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.

(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact owner@bugs.debian.org
immediately.)


-- 
595223: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=595223
Debian Bug Tracking System
Contact owner@bugs.debian.org with problems
--- Begin Message --- 
Package: linux-image-2.6-xen-amd64
Version: 2.6.32+28
Severity: normal

Hi,

with debian squeeze kernel my Sky2PC/SkyStar 2 DVB-S rev 2.6 is not able to
scan for channels. It's the same in arch i386 and amd64. When i use the stable
Lenny kernel everything is ok. The modules are loaded sucessfully, but i'm 
not able to scan for channels. Attached you can find the output of dmesg, 
lspci-vv and scan.

dmesg:
[    1.458718] udev: starting version 160
[    1.914121] input: PC Speaker as /devices/platform/pcspkr/input/input1
[    1.994384] Error: Driver 'pcspkr' is already registered, aborting...
[    2.107652] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
[    2.117598] flexcop-pci: will use the HW PID filter.
[    2.117653] flexcop-pci: card revision 2
[    2.117682] b2c2_flexcop_pci 0000:00:00.0: enabling device (0000 -> 0003)
[    2.117777] b2c2_flexcop_pci 0000:00:00.0: Xen PCI enabling IRQ: 21
[    2.117791]   alloc irq_desc for 21 on node 0
[    2.117794]   alloc kstat_irqs on node 0
[    2.132209] DVB: registering new adapter (FlexCop Digital TV device)
[    2.134257] b2c2-flexcop: MAC address = 00:d0:d7:12:34:b0
[    2.134848] CX24123: cx24123_i2c_readreg: reg=0x0 (error=-121)
[    2.134855] CX24123: wrong demod revision: 87
[    2.369535] b2c2-flexcop: found 'ST STV0299 DVB-S' .
[    2.369549] DVB: registering adapter 0 frontend 0 (ST STV0299 DVB-S)...
[    2.369620] b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S rev 2.6' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
[    2.492035] Adding 2097144k swap on /dev/xvda1.  Priority:-xtents:1 across:2097144k SS
[    2.619564] EXT3 FS on xvda2, internal journal


lspci-vv:
lspci -vv
00:00.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card (rev 02)
        Subsystem: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 64
        Interrupt: pin A routed to IRQ 21
        Region 0: Memory at feaf0000 (32-bit, non-prefetchable) [size=64K]
        Region 1: I/O ports at bc00 [size=32]
        Kernel driver in use: b2c2_flexcop_pci


scan:
scan /usr/share/dvb/dvb-s/Astra-19.2E > /tmp/channels.conf
scanning /usr/share/dvb/dvb-s/Astra-19.2E/dvb-s/Astra-19.2E > /tmp/channels.conf 
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
initial transponder 12551500 V 22000000 5
>>> tune to: 12551:v:0:22000
DVB-S IF freq is 1951500
WARNING: filter timeout pid 0x0011
WARNING: filter timeout pid 0x0000
WARNING: filter timeout pid 0x0010
dumping lists (0 services)
Done.


Thanks in advance,
regards
Herbert


-- System Information:
Debian Release: squeeze/sid
  APT prefers testing
  APT policy: (500, 'testing')
Architecture: amd64 (x86_64)

Kernel: Linux 2.6.32-5-xen-amd64 (SMP w/1 CPU core)
Locale: LANG=C, LC_CTYPE=C (charmap=ANSI_X3.4-1968)
Shell: /bin/sh linked to /bin/dash

Versions of packages linux-image-2.6-xen-amd64 depends on:
ii  linux-image-2.6.32-5-xen-amd6 2.6.32-20  Linux 2.6.32 for 64-bit PCs, Xen d

linux-image-2.6-xen-amd64 recommends no packages.

linux-image-2.6-xen-amd64 suggests no packages.

-- no debconf information

--- End Message ---
--- Begin Message --- 
Hi,
your bug has been filed against the "linux-2.6" source package and was filed for
a kernel older than the recently released Debian 7.0 / Wheezy with a severity
less than important.

We don't have the ressources to reproduce the complete backlog of all older kernel
bugs, so we're closing this bug for now. If you can reproduce the bug with Debian Wheezy
or a more recent kernel from testing or unstable, please reopen the bug by sending
a mail to control@bugs.debian.org with the following three commands included in the
mail:

reopen BUGNUMBER
reassign BUGNUMBER src:linux
thanks

Cheers,
        Moritz

--- End Message ---
Reply to: