[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#653314: marked as done (e1000e: Wake-on-lan from hibernate broken since 2.6.32-36)

Your message dated Fri, 31 May 2013 18:02:20 +0200
with message-id <20130531160220.GA10794@inutil.org>
and subject line Re: Bug#653314: e1000e: Wake-on-lan from hibernate broken since 2.6.32-36
has caused the Debian Bug report #653314,
regarding e1000e: Wake-on-lan from hibernate broken since 2.6.32-36
to be marked as done.

This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.

(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact owner@bugs.debian.org
immediately.)


-- 
653314: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=653314
Debian Bug Tracking System
Contact owner@bugs.debian.org with problems
--- Begin Message --- 
Package: linux-2.6
Version: 2.6.32-39
Severity: normal
Tags: squeeze

Between 2.6.32-35 and 2.6.32-36, the ability to wake-on-lan from
suspend-to-disk got lost for my mainboard. Waking from poweroff and from
suspend-to-ram still works. This is probably related to bug #627700. The
bug is present up to the current 2.6.32-39. Mainboard is an Intel
DB43LD. Hibernating via hibernate-1.99-1.1, module is not blacklisted.

lspci -n:
00:19.0 0200: 8086:10de (rev 02)

lspci -vv:
00:19.0 Ethernet controller: Intel Corporation 82567LM-3 Gigabit Network
Connection (rev 02)
	Subsystem: Intel Corporation Device 0025
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx+
	Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
	Latency: 0
	Interrupt: pin A routed to IRQ 27
	Region 0: Memory at d0500000 (32-bit, non-prefetchable) [size=128K]
	Region 1: Memory at d0524000 (32-bit, non-prefetchable) [size=4K]
	Region 2: I/O ports at f100 [size=32]
	Capabilities: [c8] Power Management version 2
		Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
		Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
	Capabilities: [d0] MSI: Enable+ Count=1/1 Maskable- 64bit+
		Address: 00000000fee0300c  Data: 41c1
	Capabilities: [e0] Vendor Specific Information: Len=06 <?>
	Kernel driver in use: e1000e

ethtool:
Settings for eth0:
	Supported ports: [ TP ]
	Supported link modes:   10baseT/Half 10baseT/Full
	                        100baseT/Half 100baseT/Full
	                        1000baseT/Full
	Supports auto-negotiation: Yes
	Advertised link modes:  10baseT/Half 10baseT/Full
	                        100baseT/Half 100baseT/Full
	                        1000baseT/Full
	Advertised pause frame use: No
	Advertised auto-negotiation: Yes
	Speed: 100Mb/s
	Duplex: Full
	Port: Twisted Pair
	PHYAD: 2
	Transceiver: internal
	Auto-negotiation: on
	MDI-X: on
	Supports Wake-on: pumbag
	Wake-on: g
	Current message level: 0x00000001 (1)
	Link detected: yes

syslog 2.6.32-35:
[    4.177719] e1000e: Intel(R) PRO/1000 Network Driver - 1.0.2-k2
[    4.177722] e1000e: Copyright (c) 1999-2008 Intel Corporation.
[    4.192986] e1000e 0000:00:19.0: PCI INT A -> GSI 20 (level, low) ->
IRQ 20
[    4.192994] e1000e 0000:00:19.0: setting latency timer to 64
[    4.193083] e1000e 0000:00:19.0: irq 27 for MSI/MSI-X
[    8.068727] e1000e 0000:00:19.0: irq 27 for MSI/MSI-X
[    8.124136] e1000e 0000:00:19.0: irq 27 for MSI/MSI-X
[    9.709290] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow
Control: RX/TX
(initiate hibernate)
[  156.996938] e1000e 0000:00:19.0: PCI INT A disabled
[  156.996944] e1000e 0000:00:19.0: PME# enabled
[  156.996951] e1000e 0000:00:19.0: wake-up capability enabled by ACPI
[  157.015284] ACPI: Preparing to enter system sleep state S4
(wake on lan)
[  157.384859] ACPI: Waking up from system sleep state S4
[  157.400032] e1000e 0000:00:19.0: restoring config space at offset 0xf
(was 0x100, writing 0x10a)
[  157.400047] e1000e 0000:00:19.0: restoring config space at offset 0x1
(was 0x100000, writing 0x100007)
[  157.504155] e1000e 0000:00:19.0: PCI INT A -> GSI 20 (level, low) ->
IRQ 20
[  157.504159] e1000e 0000:00:19.0: setting latency timer to 64
[  157.504168] e1000e 0000:00:19.0: wake-up capability disabled by ACPI
[  157.504172] e1000e 0000:00:19.0: PME# disabled
[  157.504200] e1000e 0000:00:19.0: irq 27 for MSI/MSI-X
[  159.228855] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow
Control: RX/TX

syslog 2.6.32-36:
[    4.208513] e1000e: Intel(R) PRO/1000 Network Driver - 1.2.20-k2
[    4.208515] e1000e: Copyright(c) 1999 - 2011 Intel Corporation.
[    4.208552] e1000e 0000:00:19.0: PCI INT A -> GSI 20 (level, low) ->
IRQ 20
[    4.208560] e1000e 0000:00:19.0: setting latency timer to 64
[    4.208638] e1000e 0000:00:19.0: irq 27 for MSI/MSI-X
[    4.522391] e1000e 0000:00:19.0: eth0: (PCI Express:2.5GB/s:Width x1)
00:27:0e:02:95:35
[    4.522394] e1000e 0000:00:19.0: eth0: Intel(R) PRO/1000 Network
Connection
[    4.522433] e1000e 0000:00:19.0: eth0: MAC: 8, PHY: 8, PBA No: FFFFFF-0FF
[    8.312251] e1000e 0000:00:19.0: irq 27 for MSI/MSI-X
[    8.368575] e1000e 0000:00:19.0: irq 27 for MSI/MSI-X
[    9.993387] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow
Control: Rx/Tx
[    9.993390] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO
(initiate hibernate)
[  174.706368] e1000e 0000:00:19.0: PCI INT A disabled
[  174.706373] e1000e 0000:00:19.0: PME# enabled
[  174.706381] e1000e 0000:00:19.0: wake-up capability enabled by ACPI
[  174.723245] ACPI: Preparing to enter system sleep state S4
(failed attempt to wake-on-lan, manual start)
[  175.096864] ACPI: Waking up from system sleep state S4
[  175.112028] e1000e 0000:00:19.0: restoring config space at offset 0xf
(was 0x100, writing 0x10a)
[  175.112043] e1000e 0000:00:19.0: restoring config space at offset 0x1
(was 0x100000, writing 0x100007)
[  175.216145] e1000e 0000:00:19.0: wake-up capability disabled by ACPI
[  175.216149] e1000e 0000:00:19.0: PME# disabled
[  175.216207] e1000e 0000:00:19.0: irq 27 for MSI/MSI-X
[  175.218145] e1000e 0000:00:19.0: eth0: MAC Wakeup cause - Unicast Packet
(note the wakeup cause entry - it just did not wake up)
[  176.884961] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow
Control: Rx/Tx
[  176.884963] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO

--- End Message ---
--- Begin Message --- 
Version: 3.1.5-1

On Tue, Dec 27, 2011 at 11:56:10PM +0100, Udo Richter wrote:
> Am 27.12.2011 21:56, schrieb Ben Hutchings:
> > Can you test whether wake-on-LAN works with the current version in
> > testing (3.1.5-1)?  You will need to upgrade initramfs-tools and
> > linux-base to install the later kernel version, but nothing else.
> 
> Seems to be working fine with 3.1.5-1, suspending to disk, to ram, and
> waking from poweroff. I'm back on 2.6.32-35 though, would have to
> resolve some kernel dependencies before upgrading permanently.

Closing, then.

Cheers,
        Moritz

--- End Message ---
Reply to: