Bug#690320: netxen_nic using only 1 interrupt
Package: firmware-netxen
Version: 0.36
After upgrade firmware-netxen NIC using only 1 of 4 interrupts
Network-adapter:
Model: "Hewlett-Packard Company NC522SFP Dual Port 10GbE Server Adapter"
# modinfo netxen_nic
filename:
/lib/modules/3.2.0-3-amd64/kernel/drivers/net/ethernet/qlogic/netxen/netxen_nic.ko
firmware: phanfw.bin
version: 4.0.77
license: GPL
description: QLogic/NetXen (1/10) GbE Intelligent Ethernet Driver
srcversion: 85607F21190BD03CFF98328
alias: pci:v00004040d00000100sv*sd*bc02sc00i00*
alias: pci:v00004040d00000025sv*sd*bc02sc00i00*
alias: pci:v00004040d00000024sv*sd*bc02sc00i00*
alias: pci:v00004040d00000005sv*sd*bc02sc00i00*
alias: pci:v00004040d00000004sv*sd*bc02sc00i00*
alias: pci:v00004040d00000003sv*sd*bc02sc00i00*
alias: pci:v00004040d00000002sv*sd*bc02sc00i00*
alias: pci:v00004040d00000001sv*sd*bc02sc00i00*
depends:
intree: Y
vermagic: 3.2.0-3-amd64 SMP mod_unload modversions
parm: auto_fw_reset:Auto firmware reset (0=disabled, 1=enabled
(int)
# ethtool -i eth2
driver: netxen_nic
version: 4.0.77
firmware-version: 4.0.588
bus-info: 0000:04:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: no
# cat /proc/interrupts | grep eth2
91: 1988135 58957560 0 0 0 0
0 0 0 0 0 0
PCI-MSI-edge eth2[0]
92: 0 0 0 0 0 0
0 0 0 0 0 0
PCI-MSI-edge eth2[1]
93: 0 0 0 0 0 0
0 0 0 0 0 0
PCI-MSI-edge eth2[2]
94: 0 0 0 0 0 0
0 0 0 0 0 0
PCI-MSI-edge eth2[3]
# dmesg | grep netxen
[ 2.974019] netxen_nic 0000:04:00.0: PCI INT A -> GSI 32 (level, low)
-> IRQ 32
[ 2.974034] netxen_nic 0000:04:00.0: setting latency timer to 64
[ 2.974282] netxen_nic 0000:04:00.0: 2MB memory map
[ 3.199449] netxen_nic 0000:04:00.0: Gen2 strapping detected
[ 3.199478] netxen_nic 0000:04:00.0: using 64-bit dma mask
[ 3.199793] netxen_nic: Dual XGb SFP+ LP Board S/N CB15BK1249 Chip
rev 0x42
[ 3.199796] netxen_nic 0000:04:00.0: firmware v4.0.585 [legacy]
[ 3.200448] netxen_nic 0000:04:00.0: irq 91 for MSI/MSI-X
[ 3.200455] netxen_nic 0000:04:00.0: irq 92 for MSI/MSI-X
[ 3.200463] netxen_nic 0000:04:00.0: irq 93 for MSI/MSI-X
[ 3.200469] netxen_nic 0000:04:00.0: irq 94 for MSI/MSI-X
[ 3.200482] netxen_nic 0000:04:00.0: using msi-x interrupts
[ 3.200904] netxen_nic 0000:04:00.0: eth2: XGbE port initialized
[ 3.200921] netxen_nic 0000:04:00.1: PCI INT A -> GSI 32 (level, low)
-> IRQ 32
[ 3.200929] netxen_nic 0000:04:00.1: setting latency timer to 64
[ 3.201163] netxen_nic 0000:04:00.1: 2MB memory map
[ 3.201285] netxen_nic 0000:04:00.1: using 64-bit dma mask
[ 3.201599] netxen_nic 0000:04:00.1: firmware v4.0.585 [legacy]
[ 3.201628] netxen_nic 0000:04:00.1: irq 95 for MSI/MSI-X
[ 3.201636] netxen_nic 0000:04:00.1: irq 96 for MSI/MSI-X
[ 3.201642] netxen_nic 0000:04:00.1: irq 97 for MSI/MSI-X
[ 3.201650] netxen_nic 0000:04:00.1: irq 98 for MSI/MSI-X
[ 3.201663] netxen_nic 0000:04:00.1: using msi-x interrupts
[ 3.202093] netxen_nic 0000:04:00.1: eth3: XGbE port initialized
[ 22.336153] netxen_nic: eth2 NIC Link is up
Reply to: