Bug#690845: ethtool: incorrect WoL detection on Broadcom NX II rev < 12
On Fri, 2012-10-19 at 02:30 +0100, Ben Hutchings wrote:
> Teodor MICU reported that:
> > On Broadcom NX II rev < 12 network interfaces it's not possible to activate
> > WoL using 'ethtool' (it can only be done from the MBA Configuration Menu).
> >
> > However, even if "Pre-boot Wake On LAN" was enabled 'ethtool' doesn't
> > see this change:
> > Supports Wake-on: d
> > Wake-on: d
> >
> > I've just tested that WoL works for this system.
>
> He's been using Linux 2.6.32 and Linux 3.2, but there don't seem to have
> been any later changes to WoL support in bnx2.
>
Teodor MICU, please provide lspci -vvv and ethtool -i eth? on the
Broadcom bnx2 device. Thanks.
Reply to: