[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#655941: iwlagn: my wifi card doesn't works - Intel Corporation Centrino Wireless-N 1000 [8086:0084]

Andrey wrote:

> $ sudo ip link set wlan0 up
> $ sudo iw dev wlan0 scan
> BSS XX:XX:XX:XX:00:03 (on wlan0)
>     Information elements from Probe Response frame:
>     SSID: repeat
>     Supported rates: 1.0* 2.0* 5.5* 11.0* 18.0 24.0 36.0 54.0
>     DS Parameter set: channel 10
>     ERP: Barker_Preamble_Mode
>     Extended supported rates: 6.0 9.0 12.0 48.0
> BSS XX:XX:XX:XX:18:ed (on wlan0)
> ----- output cuted off -----
> $ sudo iw dev wlan0 connect -w repeat
> wlan0 (phy #0): failed to connect, status: 1: Unspecified failure

Thanks.  Could we have the corresponding "dmesg" output snippet, too?
(ideally with notes on how the timing corresponds to the commands run)

Your original report included a log with

	[ 4309.262135] iwlagn 0000:03:00.0: RF_KILL bit toggled to enable radio.
	[ 6069.680858] iwlagn 0000:03:00.0: RF_KILL bit toggled to disable radio.

Is that when you switched the hardware rfkill switch?  Is the rfkill
switch set to "enabled" or "disabled" now?

Please also try version 3.2-rc7 from experimental.  Full "dmesg"
output from booting up and reproducing the problem would be useful.
If it also reproduces the problem (and I don't see any reason for it
not to) we can take this upstream.

Hope that helps,

Reply to: