Bug#647866: Network: Packages over hub via bnc not received
Am 14.11.2011 21:29, schrieb Ben Hutchings:
> On Mon, Nov 14, 2011 at 08:46:58PM +0100, debian wrote:
>>
>> Am 14.11.2011 01:52, schrieb Ben Hutchings:
>>> On Sun, 2011-11-13 at 14:15 +0100, debian wrote:
>>>> Am 09.11.2011 06:08, schrieb Ben Hutchings:
>>>>
>>>> [...]
>>>>> Can you test Linux 3.0 (from testing/unstable) on this system? If that
>>>>> has the same problem then I can ask the upstream developers to help. Ben.
>>>> Now I tried to compile kernel 3.0.8 from www.kernel.org. Compilation
>>>> worked but there is any problem when booting (because of embedded system
>>>> I can not see the kernel boot msg).
>>>> To check if I have a problem with compiling/installing Selfmade kernel I
>>>> created kernel 2.6.38 by myself. This is working fine
>>>>
>>>> So I took a ready made .deb file from community (uname -r
>>>> 3.0.0-rc6-bug-wl). Now I can boot an can login.
>>>>
>>>> Unfortunately, the network system's behaviour is the same as before
>>>> described above in this thread.
>>>> Do you think another kernel would help?
>>> I should have asked this earlier, but can you send the output of
>>> 'ethtool eth0' from one of the kernel versions with this problem?
>> Linux debian 2.6.38-dockstar-own-debug #3 Sun Nov 13 22:53:42 CET 2011
>> armv5tel
>>
>> driver: mv643xx_eth
>> version: 1.4
>> firmware-version: N/A
>> bus-info: platform
> Did I say to use the -i option? No I did not.
root@debian:~# ethtool eth0
Settings for eth0:
Supported ports: [ TP AUI BNC MII FIBRE ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 10Mb/s
Duplex: Half
Port: MII
PHYAD: 0
Transceiver: external
Auto-negotiation: on
Link detected: yes
>
> Ben.
>
>>> Ben.
>>>
Reply to: