Bug#640391: Test result
On Sat, Oct 08, 2011 at 08:48:20PM +0200, Bart Hartgers wrote:
> the electrical properties, and says nothing on how to control it over
> the usb bus. So not helpful in our case.
>
> I compared the registers accessed by the original driver to the new
> one, and I found one register that is only accessed in the new driver.
> From the windows driver, I could see it had something to do with
> baudrate selection. That said, it never actually affected the baudrate
> on my hardware. But perhaps it does something bad on yours. I removed
> the access to that register to see if it helps.
Sorry. I have just done several tests, and they all failed in just the
usual way :-(
I have not got the serial breakout box and any instrumentation out, so
I can't be absolutely sure that the gps cable is making a good
connection. I will check properly tomorrow, but I am pretty
certain that the test version is behaving just as before.
Very disappointing: sorry again to be the bearer of bad news...
ael
Reply to: